If your garage door is not operating properly, it can be both an annoyance and a safety issue. At Sam’s Garage Doors, we specialize in fixing uneven or sagging garage doors. We will provide you with an estimate for the repair of your door, including all labour and parts needed to make sure that your door is working correctly again!

The most common signs that you may have an uneven or sagging garage door include the following:

The most common signs that you may have an uneven or sagging garage door include the following:

  • Uneven door track and panels
  • Creaking (especially when opening and closing)
  • A sagging or unbalanced door
  • The door won’t go up or down

Uneven Door Track and Panels

The first thing to do is determine if the problem is with your garage door or with its tracks. The track is what holds up your door and allows it to move up and down smoothly. If you notice that one side of the track has sunken into the floor, then this is likely what’s causing your doors to sag on one side.

To fix this issue, simply remove some of the screws that are holding together pieces of wood in place (usually two per board) until only four remain attached per board: two at each end with no gaps between them; then remove those remaining four screws and replace them with longer ones, so there isn’t any space between each piece anymore.

You’ll also want to check if any panels are unevenly spaced apart from each other by measuring between opposite sides of each panel’s edge while they’re lying flat on top of one another; if there’s more than 1/16th inch difference between measurements taken at opposite ends, then adjust accordingly until everything lines up properly again before reattaching any hardware back onto both sides simultaneously using either glue or nails depending upon which method works best for your situation

Creaking

If you hear a creaking noise when the door is opening or closing, it’s likely that your springs are broken or loose. If so, they will need to be replaced by a professional garage door repair company like Sam’s Garage Doors.

You can also try tightening the springs yourself if they aren’t broken but still make squeaking noises when opening or closing the garage door. This can be done by removing one of the top hinges from its bracket and placing it back on with a pair of pliers—this should tighten up any loose screws or bolts inside that may have caused your problem in the first place

A Sagging or Unbalanced Door

If the door sags or is unbalanced, it may be time to replace the springs. To determine if this is the case, you will need to lift up one side of your garage door and hold it with one hand. Then, release your grip and see how long it takes for the other side of your garage door to hit its stop point.

If this happens in less than three seconds, then there’s probably no problem with your spring set-up; however, if it takes longer than that—or if there’s any noticeable bounce after releasing pressure from both sides—then chances are good that some work needs doing on those springs (or perhaps other parts).

If you require garage door maintenance, repairs or emergency service, contact us today at 604-554-0145.